TM 5-4320-300-14
6-8. CYLINDER LINER (CONT)
Location/Item
Action
Remarks
NOTE
Measure inside diameter, out-of-round, and taper, at
the WY and XZ axis, for each point (A through G)
shown.
5.
Inside
With a bore gage measure
diameter
inside diameter of liner.
It should not exceed
3.8767 inches
(98.468 mm).
6.
Outside
Measure outside diameter at seal
diameter
ring surface. It should be between
4.4850 and 4.4860 inches
(113.919 and 113.944 mm).
7.
Out-of-
Measure inside diameter out-of-
round
round. It should not exceed
0.002 inch (0.0508 mm).
8.
Taper
Measure inside diameter taper.
It should not exceed 0.001
inch (0.0254 mm).
6-50