TM 5-4320-300-14
6-7. CYLINDER HEAD AND BLOCK(CONT)
Location/item
Action
Remarks
NOTE
If cylinder head has not been removed from engine, remove it per paragraph 5-18.
CAUTION
When setting the cylinder head down on the valve side, support it on 2 inch (51 mm) thick wood
blocks to protect cam followers. Equipment damage could result if this procedure is not followed.
2.
Cylinder head
Set cylinder head on its side with exhaust mani-
placement
fold studs in an upright position. Then tip the
head over and position it (with exhaust valves
down) on wood blocks.
6-27