TM 5-4320-300-14
4-34. LOW OIL PRESSURE CUTOUT SWITCH (CONT)
Location/Item
Action
Remarks
REMOVAL
2. Wires
Tag wires for identification. Remove terminal
nuts. Remove wires. Note relative position of
terminals.
3. Low oil
Unscrew switch from female pipe tee on cyl-
pressure
inder block, and discard.
cutout switch
INSTALLATION
4. Low oil
Screw replacement switch into female pipe tee
pressure
in cylinder block. Tighten securely. Make sure
cutout switch
terminals are positioned approximately the
same as observed in step 2, above.
5. Wires
Install wires as described on tags. Remove tags.
Install terminal nuts and tighten securely.
4-140