TM 5-4320-300-14
4-30. STARTING AID CONTROL CABLE (CONT)
Location/Item
Action
Remarks
3. Wire stop
Loosen several turns
adjusting
until wire slides away
screw
from control valve,
out of wire stop and
cable guide.
4. Control cable
Slide up and out of
control panel box.
Remove mounting
nut from cable.
REPLACEMENT
5. Control cable
Remove mounting nut from replacement con-
trol cable. Slide cable through mounting hole
in control panel box.
6.
Mounting nut
Slide nut up control cable and tighten.
7.
Control cable
Push control knob in all the way. Route cable
over to control valve; slip cable into cable
guide and wire into wire stop.
8. Wire stop
Adjust for maximum wire length between
wire stop and cable guide. Tighten wire stop
adjusting screw.
9. Tie wraps
Use new tie wraps to secure control cable
to main wiring harness.
10. Control cable
Test cable operation. If necessary, adjust
wire in wire stop.
4-133