TM 5-4320-300-14
4-17. MUFFLER (CONT)
Location/Item
Action
Remarks
4.
Seal clamp
Remove and discard.
5.
Heat shield
Place muffler on flat surface
mounting
and note relative position
bands
of bands to muffler inlet.
Measure distance between
bands and record. Loosen
clamp screw and nut.
Slide bands off muffler.
Discard muffler.
INSPECTION
6. Muffler mount-
If loose on engine cover, tighten. If damaged, remove
ing bands
and replace. Tighten mounting bolts securely.
7.
Heat shield
Inspect for damage to bands, clamp screws and nuts,
mounting bands
and threaded holes. Replace if damaged.
INSTALLATION/REPLACEMENT
8.
Heat shield
Install onto new muffler. Position bands as noted
mounting bands
in 5, above. Tighten clamp screw and nut.
4-92