TM 5-4320-300-14
Table 4-2. Organizational Maintenance Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 4. Check START pushbutton continuity.
Disconnect battery by pulling and turn-
ing battery disconnect switch.
Use
multimeter type TS-352 B/U to check
the START pushbutton. Connect the
multimeter to the two terminals on the
rear of the START pushbutton. Set
the multimeter to 10 megohms and
press the START pushbutton.
The
multimeter should indicate zero re-
sistance if the button is functioning
properly.
If switch is faulty, replace in
accordance with paragraph 4-41.
Step 5. Check for internal engine seizure. Try to start engine with starter motor.
If the starter motor engages but cannot be rotated a complete revolution,
there is internal damage. Notify direct support maintenance.
4-35