TM 5-4320-200-13 & P
Refer to paragraph 4-3.3.
Repeat removal procedure in
This section contains testing and repair procedures for the
Remove all components from frame (para 4-3.3 a).
Cleaning and Inspection.
Clean and inspect motor (para 4-3.3 b).
Using a suitable test lamp circuit, test for continuity
between each of the motor wires.
Replace the motor if lamp does not
Test for grounds between one motor (any one) wire and frame
If lamp does light, replace the motor.
Disassemble the motor and replace components as needed.
Refer to figure 5-1 for electric motor component breakdown.