Silicone compound, MIL-S-8660

TM-10-4930-236-13P Tank and Pump Unit Liquid Dispensing; for Truck Mounting Mil Design Tank and Pump Unit Electric Motor Driven Model (97403) Manual
Page Navigation
124

TM 10-4930-236-13&P e. Insert shaft (32) through piston (44) and install retaining ring (43). f. Lower assembled parts into valve body (33) making sure that cam (36) goes to the rear of body. g. Insert shaft (28) with pins (31) through opening in body and into the cam (36). WARNING Silicone compound, MIL-S-8660, is toxic to skin, eyes and respi ratory tract. Good general venti lation is normally adequate. h. Apply silicone compound to O-ring pack- ing (29) and install O-ring on gland (27). i Install gland (27) over shaft (28) and screw gland into body (33). j Install seal/retainer assembly (30) in gland and install lever (26) and pin (25). k Install spring (24) between lever (26) and body (33), then operate lever by hand to make sure that spring (26) pulls piston (44) firmly into place. I. Install tubes (46 and 47) and screen (23). m Install seal (22) and retaining ring (21) in cap (17). WARNING Parts under spring tension can cause serious injury. Take extreme care when releasing parts under spring tension. n. Place spring (20) over shaft (32) and install seal (19), garter spring (18), cap (17) and screws (16). o. Position pilot assembly (15) on PRIMARY port and plug (14) on SECONDARY port of cap (17) and install screws (13). p. Apply sealing compound to threads of plug (48) and install plug in valve body (33). 5-22

Privacy Statement
Press Release
Contact