(b) Replace defective gasket.
Install gasket (14, fig. 4-31); close
filler plug (13), and secure with hinge assembly (12).
To remove the tiedown assemblies (15, fig. 4-31)
the drag loops have to be removed first.
Remove nuts and washers at
each end of loop as well as nut in center.
Loosen nuts on tiedown
assembly and remove loop and tiedown assembly (fig. 4-31).
Inspect for cracks, breaks, and other damage.
Reinstall tiedown assemblies and drag loops.
Tighten nuts on tiedown assembly and the nuts and washers at each end
of loop as well in center.
DISCHARGE VALVE AND CAM LEVER.
Inspect discharge valve (16, fig. 4-31) and cam lever (17)
for cracks, breaks, defects and other damage.
If replacement of the discharge valve and/or cam lever is
necessary , notify direct support maintenance.