TM 10-4320-310-14
5-10.
INSPECT/REPLACE CYLINDER HEAD AND VALVE ASSEMBLY (Continued)
3
Remove four hexagon nuts (1) and washers (5) from
four studs (2). Remove rocker shaft (3) with rockers,
lifting eye and fuel tank bracket. Remove two air
shields. Remove deflector (4).
NOTE
Record thickness of gasket (2) to aid in
selection of new gasket during installation.
4
Remove cylinder head (1) and gasket (2). Discard
gasket.
5
Remove pushrod (1) and complete pushrod (2) from
protection tubes (3).
6
Remove protection tubes (3), preformed packing (4),
shims (5) and pressure springs (6). Discard
preformed packing.
NOTE
Complete pushrod (2) is located on the
injection pump side of the engine.
5-18