LUBE OIL PUMP ASSEMBLY REPAIR (CONT).
Install lube oil pump cover as follows:
Install dowel (24) into pump body (3) if removed. The dowel pin must protrude between 0.990 and 1.010
inches (22.15 and 25.65 mm) above pump body surface.
Put new gasket (25) over dowel (24) and line up with bolt holes in pump body (3).
Install pump cover (26) to pump body (3), and hit cover lightly with rubber hammer to push onto dowel (24).
Install four capscrews (27) and captive washers and tighten to 30 to 35 ft-lbs (40 to 47 Nm) torque.
Rotate gear (21) to make sure shaft is turning freely in pump.
Apply sealing compound or antiseizing tape to threads of pipe plug (28) and install plug to pump cover (26).
Install cover plate (29) with new gasket (30), and secure with capscrews (31) and lockwashers (32).
Install lube oil pump in accordance with paragraph 3-30.