TURBOCHARGER (HC3-16) REPAIR (CONT).
All parts and work area must be free of grease, oil, and dirt to keep abrasives out of the
turbocharger during assembly.
Coat all bearings, thrust bearing, thrust rings, and
piston ring with a light coat of lubricating oil.
Install new snap ring (1) in turbine end of bearing
Install new bearing (3), new oil control sleeve (4), and
outer snap ring (5).
Install heat shield (6) and retaining ring (7).
Install new piston ring (8) against shoulder of shaft and
wheel assembly (9).
Insert shaft and wheel assembly (9) through bearing