TM 10-4320-307-24
3-36
CYLINDER HEAD ASSEMBLY/INSPECT / REPLACE (CONT)
9.
Install injectors (4) in accordance with paragraph
3-34.
10.
Install new O-rings (5) and position two fuel
crossover connections (6) in place on cylinder
heads.
11.
Install capscrews and lockwashers (7) and tighten
to 35 in-lbs (4 N.m) torque.
12.
Install fuel supply and fuel drain tubes.
13.
Install all brackets and clamps.
14.
Install valve crossheads as follows:
a.
Lubricate valve stems and crosshead guides with clean oil.
b.
Install crossheads on crosshead guides with adjusting screw toward water manifold side of engine.
c.
Loosen adjusting screw locknut. Loosen adjusting screw one full turn.
d.
Use light finger pressure to hold crosshead in position, and tighten the adjusting screw until it touches top of
valve stem.
e.
Hold crosshead adjusting screw in position, and tighten the locknut to 30 ft-lbs (40 N.m) torque. If torque
wrench adapter is used, tighten the locknut to 25 ft-lbs (35 N.m) torque.
3-134