TM 10-4320-307-24
3-32 LUBE OIL COOLER ASSEMBLY INSPECT/TEST/REPAIR (CONT.)
14.
Install bypass filter head (15) over end of cooler
element.
15.
Move filter head assembly (15) up and down to make
sure pressure sensing piston moves freely in housing
bore.
16.
Use your hand to press filter head (15) down over end
of oil cooler element until it contacts gasket.
17.
Hold filter head (15) in this position, and install
capscrews, lockwashers, and washers (16). Tighten
six capscrews to 35 ft-lbs (45 Nm) torque.
18.
Install capscrews (17) through cooler housing (3) and
install gasket (18) over capscrews.
19.
Position oil cooler support (19) on cooler housing (3).
20.
Tighten six capscrews (17) to 35 ft-lbs (45 Nm)
torque.
21.
Install oil cooler assembly in accordance with
paragraph 2-52.
3-112