TM 10-4320-307-24
3-26
WATER PUMP ASSEMBLY REPAIR (CONT ).
ASSEMBLY:
1.
Apply a light coat of clean lubricating oil to shaft (1).
2.
Use fixture ST-658 to support new inner bearing (2).
3.
Push pulley end of shaft (1) through bearing until bearing is against larger diameter shoulder of shaft.
4.
Use fixture ST-658 to support new outer bearing (3).
5.
Install bearing spacer (4) onto shaft. Push shaft and spacer through bearing until bearing is againstspacer.
CAUTION
To prevent damage to the bearing, make sure the inner race of the bearing is not
overloaded from contact with the spacer.
NOTE
Insure full rotation of bearings (2 and 3).
3-78