TM 10-4320-307-24
3-22
STARTER MOTOR REPAIR (CONT ).
ASSEMBLY:
1.
Assemble lever housing (1) as follows:
a.
Install bushings into nose housing (2), commutator end cap (3), and lever housing (1) as required.
b.
Install two O-rings (4).
c.
Install seal (5) and bushing (6).
d.
Install shift mechanism (7), pivot rod (8), and retaining ring (9) into lever housing.
e.
Position drive (10) and install solenoid (11) to lever housing using three screws (12).
f.
Install shaft nut (13).
g.
Install gasket (14) and plug (15) into lever housing (1).
2.
Assemble field frame (16) as follows:
a.
Install O-ring (17), grommet (18), and two spring pins (19) onto field frame (16).
b.
Position coils and coil retainers (20) on field frame and secure each using two screws (21).
c.
Position connector strap (22) on field frame (16) and secure using screw (23).
3.
Position lever housing (1) on field frame (16) and secure using five bolts (24).
3-64