CORROSION RESISTOR ASSEMBLY SERVICE/REPAIR/REPLACE .
This task covers:
Tool kit, general mechanic's (Item 1, Appendix B)
Filter wrench (Item 2, Appendix B)
General Safety Instructions
Lubricating oil (Item 22, Appendix C)
Coolant temperature must be below 120°F (50°C)
before working on any part of cooling system.
Well ventilated area required during operational
Wait until the temperature is below 120°F
(50°C) and close the shutoff valves before
removing the cool- ant filter element. Failure
to do so can cause person- al injury from
heated coolant spray.
Close two shutoff valves (1).
Remove and discard coolant filter (2).
Clean gasket surface on corrosion resistor head (3).