TM 10-4320-226-14
6.6.4 Engine Maintenance.
(continued)
d.
e.
f.
Do not use dry cleaning solvent without proper ventilation and clothing.
DO not smoke or use near open flame or excessive heat.
Dry cleaning
solvent is potentially dangerous to personnel and property.
Clean parts
in a well-ventilated area.
Avoid inhalation of solvent fumes.
Wear
goggles and rubber gloves to protect eyes and skin.
Wash exposed skin
thoroughly.
Flash point of solvent is 100°F to 138°F (38°C to 59°C).
Failure to obey this warning may result in personal injury or death.
Clean all parts with solvent.
Clean all tapped holes in crankcase.
Inspect crankcase for cracks. Replace cracked crankcase.
g.
6-28
Figure 6-13.
Cylinder Lining Rework.
If grooved, rework cylinder liner seating on crankcase as follows:
(1) Clean seating area.
(2) Place support bracket (figure 6-13, 1) in position, mount turning
fixture (2), and tighten retaining bolts (3) in such a manner that
turning fixture is still movable.
(3) Center refacing device and tighten bolts (3).