4.13.7 Safety Relay K1 Replacement.
This task covers:
General Mechanics Tool Kit (appendix B,
Section III, Item 1)
Equipment shut down, refer to
paragraph 126.96.36.199 or 188.8.131.52.
Control Panel Assembly Cover removed,
General Safety Instructions
To prevent rolling or sliding, do not
work on equipment that is not securely
Do not work on equipment without
following standard shop safety
Safety Relay (K1) Replacement .
To prevent rolling or sliding, do not work on equipment that is not
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personal injury.
Remove retainer clip (figure 4-47, 1) from relay (2).
Remove relay (2) from socket (3).
Install relay (2) into socket (3).
Secure relay (2) by lifting retainer clip (1) over relay (2).