4.13.5 Oil Pressure (M1), Ammeter (M2), and Tachometer/Hourmeter (M3) Replacement.
This task covers:
4.13 .5.1 Removal
4.13 .5.2 Installation
General Mechanics Tool Kit (appendix B,
Equipment Conditions (continued)
Control Panel Assembly Cover removed,
Section III, Item 1)
Tags (appendix E, Section II,
Equipment shut down, refer to
paragraph 18.104.22.168 or 22.214.171.124.
General Safety Instructions
To prevent rolling or sliding, do not
work on equipment that is not securely
Do not work on equipment without
following standard shop safety
Oil Pressure, Ammeter, and Tachometer/Hourmeter Replacement.
To prevent rolling or sliding, do not work on equipment that is not
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personal injury.
Tag and disconnect wires (figure 4-45, 1) from gauge (2).
Remove two nuts (3), lockwashers (4), and retaining bracket (5) from gauge at
back of control panel.
Remove gauge (2) from front of control panel.
gauge (2) through front of control panel.
retainer bracket (5) and lockwashers (4) on gauge at back of control