4.10.12 Alternator Maintenance.
This task covers:
General Mechanics Tool Kit (appendix B,
Section III, Item 1)
Lockwashers (TM 10-4320-226-24P)
Washers (TM 10-4320-226-24P)
Tags (appendix E, Section II, Item 12)
Equipment shut down, refer to
paragraph 22.214.171.124 or 126.96.36.199.
Alternator V-belt removed
General Safety Instructions
To prevent rolling or sliding, do not
work on equipment that is not securely
DO not work on equipment without
following standard shop safety
To prevent rolling or sliding, do not work on equipment that is not
Ensure both wheels are secure.
Do not work on alternator with negative battery cable connected.
Failure to obey these warnings may result in serious personal injury.
Disconnect negative battery cable.
Tag and disconnect alternator quick disconnect lead (figure 4-16, 1).
Remove nut (2).
Tag and disconnect wire (3).
Remove nut (4) and lockwasher (5). Tag and disconnect wire (6).
Remove bolt (7), lockwasher (8), washer (9), bolt (10), lockwasher (11),
washer (12) and alternator (13).
Position alternator (13) in place on engine.
Install, but do not fully tighten, washer (12), lockwasher (11), bolt (10),
washer (9), lockwasher (8), and bolt (7).
Install wire (6), lockwasher (5) and nut (4).
Install wire (3) and nut (2).
Connect alternator quick disconnect lead (1).
Connect negative battery cable.