LUBRICATON ORDER
LO 5-43A20-252 12
23 May 1978 (Supersedes. LO 43'262.-12, 2 August 1968
PUMP, RECIPROCATING, DIAPHRAGM,
100 GPM, LESS MIL STD ENGINE,
(REX CHAINBELT MODEL 4G)
Reference: LO 5.2805-12, and C9100-IL
Intervals and related task-hour times are based on
indicated by dotted arrow shaft on both sides
of
normal hours of operation. The task-hour time specified
equipment. Clean parts with SOLVENT, dry cleaning, or
with OIL, fuel, diesel. Dry before lubricating. Drain
is the time you need to do all the services prescribed for
a particular interval.
Change the interval if your
crankcase when HOT. Fill and check level. The lowest
level of Maintenance, authorized to lubricate a point is
lubricants are contaminated or if you are operating the
equipment under adverse operating conditions, including
indicated by one of the following: (c) Operator/crew; or
longer-than-usual operating hours. You may extend the
(O) Organizational Maintenance.
interval during periods of low activity, but you must take
adequate preservation precaution.
You can help improve this publication., If you find any
mistake or if you know of a way to improve the
*The time specified is the time required to perform all
procedures. p lease let us know.
Your letter or
services at the particular interval.
DA Form 2028 (Recommended Changes
to Publications and Blank Forms) should be
Clean fittings before lubricating. Relubricate all areas
mailed directly to:
Commander, U.S. Army Troop
exposed to water after amphibious operation. Lubricate
Support & Aviation Material Readiness Command,
point
ATTN: DRSTS-MTPS, 4300 Goodfellow Blvd. ST.
Louis, MO 63120. A reply will be furnished to you."
*TOTAL TASK-HR
*TOTAL TASK-HR
INTERVAL
TASK-HR
INTERVAL
TASK-HR
5
0.2
500
0.4
10
0.1
1000
0.3
CARD 1 OF 2